Today, an article I wrote on home canning appeared in the Topeka
Capital-Journal newspaper. It features a great basic recipe for tomato sauce,
plus a lot of tips on canning.
However, there is a story behind the article. Last month, I took my
tomatoes, jars, and recipe to the family farmhouse in Missouri .
The farm has been in my family for more than 100 years.
Mom and I spent a little over half a day making tomato
sauce. She sat at the kitchen table cutting
tomatoes and I stood at the stove cooking those tomatoes for the sauce.
Mom said, with a warm, far-away look on her face, “I
remember Granny sitting here doing this while Mom was at the stove.”
A feeling of pride washed over me as I realized the spirit
and traditions of past generations continued on through this simple act of
canning tomato sauce.
Tomato Sauce
Adapted from the Ball
Blue Book Guide to Preserving
Makes about 14 pints or 7 quarts
45 pounds of tomatoes
Bottled lemon juice
Wash the tomatoes and cut away the core and blossom ends,
plus any bad spots. Cut each tomato in half and then gently squeeze to remove
the seeds. Cut each half into quarters and place in a large pot. Bring the pot
to a simmer over medium-low to low heat and cook, stirring occasionally, until
the tomatoes break down, about 20 minutes.
Process the tomatoes through a food mill to remove the skins
and any remaining seeds. Pour the tomato pulp back into the large pot and
simmer over medium-high heat, stirring constantly to prevent scorching. Reduce
until the sauce reaches the desired thickness. (This will take some time.)
To process, start by sterilizing the jars: Place clean jars
without lids into the canner on a rack so they do not
touch the bottom. (If you
don’t have a rack, place the rings on the bottom and set the jars on top.) Fill
with water to 2 inches above the jars. Cover and heat to boiling, and then boil
for 10 minutes. After that time, turn heat to low and keep the jars in the
water until needed.
Place the flat canning lids in a sauce pan off the heat and
pour some of the liquid from the boiling pot over the top to cover. This will
soften the rubber to help the lids seal.
One at a time, remove a jar from the water. Add 1 tablespoon
lemon juice to a pint jar, 2 tablespoons to a quart jar. Fill the jar with the
hot tomato sauce, leaving 1/2-inch headspace at the top. (Using a funnel
helps.) Wipe the rim of the jar with a damp towel to clean off any drips, and
then take a flat lid from the warm water and place on top. Screw on a ring
until just tight.
Once all the jars are filled, gently place them back into
the canner. Make sure the water covers the jars by at least 1 to 2 inches and
the jars do not touch each other or the sides of the canner. Cover, bring the
canner back to a boil, and process for 35 minutes for pints and 40 minutes for
quarts.
Remove the jars from the canner and place on a dry towel to
cool completely, leaving 1 to 2 inches of space between the jars. You will hear
the lids start to pop as they seal, but it may take some time. Let the jars
cool 12 to 24 hours before checking the seal. If the ring band has loosed
during processing, do not tighten. This could interfere with the sealing
process.
To check the seal on the cooled jars, press on the lid. If
it springs back, the jar is not sealed. Also remove the ring and try to lift
the lid with your fingertips. If it stays tight, the seal is good. If a jar
doesn’t seal, just store the unsealed jar in the refrigerator and use it first.
Also refrigerate any jar after it’s opened.